manual, sysadmins, wg

collections/system_administrators/getstarted/ssh_guide/ssh_wireguard.md

@@ -69,19 +69,19 @@ To set the WireGuard connection on Linux or MAC, create a WireGuard configuratio
 
 * Copy the content **WireGuard Config** from the Dashboard **Details** window
 * Paste the content to a file with the extension `.conf` (e.g. **wg.conf**) in the directory `/etc/wireguard`
-  * ```
+    ```
     sudo nano /etc/wireguard/wg.conf
     ```
 * Start WireGuard with the command **wg-quick** and, as a parameter, pass the configuration file without the extension (e.g. *wg.conf -> wg*)
-  * ```
+    ```
     wg-quick up wg
     ```
   * Note that you can also specify a config file by path, stored in any location
-    * ```
+      ```
       wg-quick up /etc/wireguard/wg.conf
       ```
 * If you want to stop the WireGuard service, you can write the following in the terminal
-  * ```
+    ```
     wg-quick down wg
     ```
 
@@ -105,7 +105,7 @@ To set the WireGuard connection on Windows, add and activate a tunnel with the W
 As a test, you can [ping](../../computer_it_basics/cli_scripts_basics.md#test-the-network-connectivity-of-a-domain-or-an-ip-address-with-ping) the virtual IP address of the VM to make sure the WireGuard connection is properly established. Make sure to replace `VM_WireGuard_IP` with the proper WireGuard IP address:
 
 * Ping the deployment
-  * ```
+    ```
     ping VM_WireGuard_IP
     ```
 
@@ -116,7 +116,7 @@ As a test, you can [ping](../../computer_it_basics/cli_scripts_basics.md#test-th
 To SSH into the deployment with Wireguard, use the **WireGuard IP** shown in the Dashboard **Details** window.
 
 * SSH into the deployment
-  * ```
+    ```
     ssh root@VM_WireGuard_IP
     ```